MX Linux Forum

i have done it with intel tweak now it do not boot.

hdaudio hadandioC0D2: unable to configure, disabling.

now i can not boot.

very bad and terrible.

how can i make it now undone?

sisqonrw wrote: Thu Aug 18, 2022 10:31 am i have done it with intel tweak now it do not boot.

hdaudio hadandioC0D2: unable to configure, disabling.

now i can not boot.

very bad and terrible.

how can i make it now undone?

Boot from LiveUSB and remove
/etc/X11/xorg.conf.d/20-intel.conf
on the root partition of the installed system.

i have installed

MX-21.1_fluxbox_x64

it is better than

MX-21.1_fluxbox_386

and

MX-21.1_x64 and AH.

i have installed over UEFI USB Live Stick and boot always with UEFI HDD.

speed of open and using of apps is ok. could be better but it is ok.

only bad thing is intallation of apps takes a lot. for example gimp. 20 minutes are gone and he is by 23%.
why is it so i do not understand.

when i have an update it would take a week.

That sounds like the main repository you are currently connected to is having problems. Go to Repo Manager in MX Tools and switch to the repository located in Alblasserdam, The Netherlands. This repository is owned and controlled by the MX team and since you reside in Germany is close to you.

i have change it to Alblasserdam. i wanted to install libreoffice. since 12 minutes the status is 0%

unzip gimp-data ...

Have you gotten the main thing working all ok before installing these other things? Like screen and whatnot?

Maybe run speedtest on that install in a browser before installing other things.

Eadwine Rose wrote: Sat Aug 20, 2022 6:00 am Have you gotten the main thing working all ok before installing these other things? Like screen and whatnot?

Maybe run speedtest on that install in a browser before installing other things.

all other things are ok.
i have an other notebook with kubuntu. the installation is fast. for an app not more then 3 minutes.

sisqonrw wrote: Sat Aug 20, 2022 5:52 am i have change it to Alblasserdam. i wanted to install libreoffice. since 12 minutes the status is 0%

unzip gimp-data ...

The possibility exists that you are being throttled by your ISP.

It's also possible that the laptop's wifi card has died. You can easily check if the wifi card is the bottleneck by running an Ethernet cable from the laptop's RJ45 jack to your router. if the wifi card does need to be replaced, here's how:

https://www.youtube.com/watch?v=GWkxx8PkOg4&t=20s

The throttling is why I suggested the speed test. :) I mean.. that would show, I guess.

Eadwine Rose wrote: Sat Aug 20, 2022 7:34 am The throttling is why I suggested the speed test. :) I mean.. that would show, I guess.

Sorry, it's early in the morning here and I missed your suggestion.