Re: Firmware updates in MX
Posted: Mon Mar 17, 2014 4:58 pm
No problems after firmware updates here.
Working fine with wl still blacklisted and b43 "unblacklisted".
Phil
(in NC)
MX Linux Forum
Support for MX and antiX Linux distros
http://www.forum.mxlinux.org/
Firmware updates in MX
Page 2 of 2
Re: Firmware updates in MX
Posted: Mon Mar 17, 2014 5:42 pm
Re: Firmware updates in MX
Posted: Tue Mar 18, 2014 2:15 am
What I have, desktop and a wifi phone, all working still 
(though I have no idea what is in my system at this moment, I just used clonezilla to make a clone beforehand *giggle*)
(though I have no idea what is in my system at this moment, I just used clonezilla to make a clone beforehand *giggle*)Re: Firmware updates in MX
Posted: Tue Mar 18, 2014 4:28 am
I will test when I get to work in about 12 hours. I have a laptop that has a flaky wireless card. If it's too far away from the access point, (like 15 feet!) it will not connect, but when I bring it closer to the AP, it connects, then it works fine for the rest of the day and holds the connection for up to 35 feet before it drops the connection.
Re:OT! - Firmware updates in MX
Posted: Tue Mar 18, 2014 7:53 am
I had a laptop like this to repair; I eventually found that only one of the aerial connections to the wifi card had ever been pushed on! The owner insisted it had been like it from new, and was very impressed with its subsequent performance.m_pav wrote:I will test when I get to work in about 12 hours. I have a laptop that has a flaky wireless card. If it's too far away from the access point, (like 15 feet!) it will not connect, but when I bring it closer to the AP, it connects, then it works fine for the rest of the day and holds the connection for up to 35 feet before it drops the connection.
Chris
Re: Firmware updates in MX
Posted: Tue Mar 18, 2014 9:17 pm
All is well here, updated two machines,
The old hero, beater P3 desktop:
And the workhorse test machine, HP dv7-1270 laptop:
NVIDIA Corporation G96 [GeForce 9600M GT] (rev a1) - Nvidia 331.49 (smxi)
Intel Corporation PRO/Wireless 5100 AGN [Shiloh] Network Connection
Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 02).
No issues on either machine with sound, wifi, or display. Or anything.
The old hero, beater P3 desktop:
This P3 multiboots MX14rc2, antiX 13.2, SolydX, and WinXP, hence the "old hero" moniker...inxi -Fzxx, after a pause to reflect, wrote:System: Host: D815EEA2 Kernel: 3.12-0.bpo.1-686-pae i686 (32 bit, gcc: 4.6.3)
Desktop: Xfce 4.10.2 (Gtk 2.24.10) info: xfce4-panel dm: lightdm Distro: MX-14_13.99_386-xfce RC2 09 March 2014
Machine: Mobo: Intel model: D815EE2U version: AAA52399-803
Bios: Intel version: EA81520A.86A.0039.P21.0211061753 date: 11/06/2002
CPU: Single core Intel Pentium III CPU family (-UP-) cache: 512 KB flags: (pae sse) bmips: 2789.73 clocked at 1394.867 MHz
Graphics: Card: Advanced Micro Devices [AMD] nee ATI RV350 AP [Radeon 9600] bus-ID: 02:00.0 chip-ID: 1002:4150
Display Server: X.Org 1.12.4 drivers: ati,radeon (unloaded: fbdev,vesa) Resolution: 1920x1080@60.0hz
GLX Renderer: Gallium 0.4 on ATI RV350 GLX Version: 2.1 Mesa 8.0.5 Direct Rendering: Yes
Audio: Card: Intel 82801BA/BAM AC'97 Audio Controller
driver: snd_intel8x0 ports: e800 ef00 bus-ID: 00:1f.5 chip-ID: 8086:2445
Sound: Advanced Linux Sound Architecture ver: k3.12-0.bpo.1-686-pae
Network: Card: Intel 82801BA/BAM/CA/CAM Ethernet Controller
driver: e100 ver: 3.5.24-k2-NAPI port: cf00 bus-ID: 01:08.0 chip-ID: 8086:2449
IF: eth0 state: up speed: 100 Mbps duplex: full mac: <filter>
Drives: HDD Total Size: 80.0GB (-)
1: id: /dev/sda model: WDC_WD800AAJB size: 80.0GB serial: WD-WCAV3C557217
Partition: ID: / size: 9.5G used: 2.7G (30%) fs: ext4 ID: swap-1 size: 4.19GB used: 0.01GB (0%) fs: swap
Sensors: None detected - is lm-sensors installed and configured?
Info: Processes: 116 Uptime: 25 min Memory: 298.2/500.4MB Init: SysVinit v: 2.88 runlevel: 5 default: 5
Gcc sys: 4.7.2 alt: 4.6 Client: Shell (bash 4.2.371 running in xfce4-terminal) inxi: 2.0.0
And the workhorse test machine, HP dv7-1270 laptop:
NVIDIA Corporation G96 [GeForce 9600M GT] (rev a1) - Nvidia 331.49 (smxi)
Intel Corporation PRO/Wireless 5100 AGN [Shiloh] Network Connection
Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 02).
No issues on either machine with sound, wifi, or display. Or anything.
Re: Firmware updates in MX
Posted: Wed Mar 19, 2014 2:56 am
Lenovo E330 with the troublesome BCM 43228. Today was the worst ever, but if you take into account that this is the first ever Linux distro that could use the wireless on this machine, it is still the best, however, after about 20 attempts where it kept repeating a password prompt, I finally got it to connect and that was 2ft from the AP. I am now 15ft away and I have 4 bars running from a stock standard RC2 flash drive. Installed to HD and updated made no difference.
Code: Select all
$ inxi -F
System: Host: mx1 Kernel: 3.12-0.bpo.1-686-pae i686 (32 bit)
Desktop: Xfce 4.10.2 Distro: MX-14_13.99_386-xfce RC2 09 March 2014
Machine: System: LENOVO product: 33542LM version: ThinkPad Edge E330
Mobo: LENOVO model: 33542LM Bios: LENOVO version: H3ET28WW(1.11) date: 05/18/2012
CPU: Dual core Intel Core i3-2370M CPU (-HT-MCP-) cache: 3072 KB flags: (lm nx pae sse sse2 sse3 sse4_1 sse4_2 ssse3 vmx)
Clock Speeds: 1: 2134.125 MHz 2: 1472.250 MHz 3: 1312.500 MHz 4: 1377.656 MHz
Graphics: Card: Intel 2nd Generation Core Processor Family Integrated Graphics Controller
X.Org: 1.12.4 drivers: intel (unloaded: fbdev,vesa) Resolution: 1366x768@60.0hz
GLX Renderer: Mesa DRI Intel Sandybridge Mobile x86/MMX/SSE2 GLX Version: 3.0 Mesa 8.0.5
Audio: Card: Intel 7 Series/C210 Series Family High Definition Audio Controller driver: snd_hda_intel
Sound: Advanced Linux Sound Architecture ver: k3.12-0.bpo.1-686-pae
Network: Card-1: Broadcom BCM43228 802.11a/b/g/n driver: wl
IF: wlan1 state: up mac: 9c:b7:0d:e8:8b:2b
Card-2: Realtek RTL8111/8168B PCI Express Gigabit Ethernet controller driver: r8169
IF: eth1 state: down mac: 3c:97:0e:00:aa:7a
Drives: HDD Total Size: 152.0GB (5.6% used) 1: id: /dev/sda model: INTEL_SSDSC2CT12 size: 120.0GB
2: USB id: /dev/sdb model: USB_Flash_Drive size: 31.9GB
Partition: ID: / size: 2.8G used: 119M (5%) fs: rootfs ID: swap-1 size: 3.15GB used: 0.00GB (0%) fs: swap
Sensors: System Temperatures: cpu: 53.0C mobo: 51.0C
Fan Speeds (in rpm): cpu: 0
Info: Processes: 155 Uptime: 34 min Memory: 247.5/3495.7MB Client: Shell (bash) inxi: 1.9.18Re: Firmware updates in MX
Posted: Wed Mar 19, 2014 6:34 am
Interesting, I just remastered my flash drive with the updates, rebooted and this laptop connected on the 2nd try from 15 feet away. Is it a fluke or is it a difference caused by the firmware updates???? I just rebooted again with the remastered Live-USB and it connected first time!. Will have to try again tomorrow at work.