MX Linux Forum

caprea wrote: Thu Aug 13, 2020 5:36 am Maybe the output of cmst from the terminal gives a hint why connman does not launch.

I wrote cmst in terminal, it says "command not found".

I just looked at the base version of antiX. cmst is not installed on base, but there's connman-ui-gtk for the icon in taskbar.
Did you try to right-click on the icon and to enable wifi and disable wired connection ?
Afterwards you can left-click for your router.
The mouse button must be held down here (both left or right)

Can I set it up from Ceni? I tried ceni, connected to the network but still no internet connection. I can only access the router setup page (accessible by typing 192.168.0.1 in the browser). This makes me doubt that it is a configuration problem.

If you want to use ceni you have to remove connman first. There are a lot of threads about it in the antixforum.
You can follow these instructions, but for AnitX-base you have to uninstall connman and connman-ui-gtk.
Then follow steps 2-4

https://www.antixforum.com/forums/topic ... post-32414

But I would recommend to try connman once before, the way I described it above.

I will try the fix to use Ceni. I hope it will work.

I will install antiX full to get connman to work.
Edit: With antiX full, everything is working as intended.