MX-Linux KDE stuck at boot with psmouse error when using systemd boot option [Solved]

[NetWORKER]

@NetWORKER wrote

can u please give me a guide to learn sysVinit commands like how to check a service is running, enable service to run at startup etc? online i get systemctl commands to do this, so i don't know how to use there equivalent commands in sysVinit

https://www.2daygeek.com/sysvinit-vs-sy ... and-usage/

Thank you.

[Huckleberry Finn]

Thank you, too for the feedback.

I know, this is not the answer you expected but at least from original sources (and for now)

Code: Select all

pcie_aspm=	[PCIE] Forcibly enable or disable PCIe Active State Power Management.

		off	Disable ASPM.

Code: Select all

idle=	[X86]
			Format: idle=poll, idle=halt, idle=nomwait
			Poll forces a polling idle loop that can slightly
			improve the performance of waking up a idle CPU, but
			will use a lot of power and make the system run hot.
			Not recommended.
			idle=halt: Halt is forced to be used for CPU idle.
			In such case C2/C3 won't be used again.

			idle=nomwait: Disable mwait for CPU C-states

default_ps_max_latency_us: default power state max latency (μs)

APST (Autonomous Power State Transition) lets us program a table of power state transitions that the controller will perform automatically. We configure it with a simple heuristic: we are willing to spend at most 2% of the time transitioning between power states. Therefore, when running in any given state, we will enter the next lower-power non-operational state after waiting 100 * (enlat + exlat) microseconds, as long as that state's total latency is under the requested maximum latency.

We will not autonomously enter any non-operational state for which the total latency exceeds ps_max_latency_us. Users can set ps_max_latency_us to zero to turn off APST.

[Huckleberry Finn]

Actually it may also be ok without the idle=nomwait


If you like you can try these temporarily in 2-3 boots:

Press E on grub, just delete that part ( idle=nomwait ) press F10 to go on boot.

Next time (press E again...) you can try smaller numbers instead of 5500 , change it to 1000 press F10 , ... next time try 200 (... can try even 0 to completely disable APST )


If anything's better you can change them permanently in "MX Boot Options".

[Huckleberry Finn]

In the meantime:

[NetWORKER]

Actually it may also be ok without the idle=nomwait


If you like you can try these temporarily in 2-3 boots:

Press E on grub, just delete that part ( idle=nomwait ) press F10 to go on boot.

Next time (press E again...) you can try smaller numbers instead of 5500 , change it to 1000 press F10 , ... next time try 200 (... can try even 0 to completely disable APST )


If anything's better you can change them permanently in "MX Boot Options".

thanks for the explanations. i will try this method and see which one works best.