Slic3r-prusa Instalation Dependencies Solved

[zandoval]

Having to use Slic3r for my 3D printer instead of Cura which does not list my printer. After installing slic3r-prusa via synaptic it would not run. The cure is the same for Mint Linux platforms in that it needs some perl dependencies. Got it running after installing "wx-common, libopengl-perl, libwx-glcanvas-perl" via synaptic or

sudo apt-get install wx-common libopengl-perl libwx-glcanvas-perl

See: https://www.reddit.com/r/linux4noobs/co ... g_on_mint/