MX Linux Forum

megatotoro wrote: Fri Jul 05, 2019 8:27 pm I think the nightmarish experience of the OP is totally legitimate. I had a very similar experience with an HP laptop. At the end, antiX was the only distro that worked. Here is the thread about my own issues:

viewtopic.php?f=104&t=47678&p=477612#p477612

If the OP is interested in MX USB maker, antiX is worth a try.

antiX uses a 4.9 kernel as its default, which is probably why it works on that system and MX doesn't. Not to fault the 4.19 series of kernels, they work fine on most computers and are a fairly new kernel, but 4.9 plays nicer on some older or lower-spec hardware.

I opted to running my snapshot in virtual box and downgrade the kernel to 14.4...i think. I then installed AMD drivers. I then created a snapshot of the VM and surprise surprise. I successfully installed MX on the HP computer in question and it runs flawlessly. A bit of a round about way but it did the job

Please edit your original post (the pencil icon at the top right) and add [SOLVED] to the subject if you're satisfied with this solution. This makes it easier for others when they're searching the forum looking for solutions to the same question or problem. Thanks.